If you are unsure if this belt will fit your vacuum message us with your model number.  

NOTE: These belts will be shorter than the belt you took off your vacuum. Belts lose elasticity because they must be stretched to almost twice their original length. After a few months the belt will be an inch or  longer. 
Be sure your brush roll will spin freely before installing your new belt. Also make sure the belt is not pinched or restricted before you turn the vacuum on by turning the brush roll by hand before you plug the vacuum in. If your belt is restricted from spinning freely the motor shaft will melt through your new belt. This does not indicate a bad belt, it usually means the belt was installed improperly or the brush roll is not spinning as freely as it should. Please ask if you have any questions.